Fitting a Watch Strap replacements

	Tool for removing a spring bar
	The shap of the tool is a grove
	Take the measurements between the shoulders of your watch where your strap goes this to will give you the correct size of Strap and spring bar you require, So if the width measurement is 18mm then you will need a 18mm Strap or spring bar.
	The shap of the tool is a round bar, by pushing the spring bar out in this type of watch
	r.insert the grove in be tween the strap and the case of the watch then pull down releasing the spring bar.
	insert a blade in be tween the strap and the watch case pulling the blade down releasing the spring ba
	hold the watch case then inseret the lower spring bar into the spring bar hole then holding the watch and strap furmaly push down on the top of the spring bar insertting it into the top hole.
	Cut off the hold watch strap
	thread the new watch strap through the watch case anjd the spring bar
	aply glue to both parts of the watch strap and leave foe a while
	Thread the metle clips the the other side of the watch strap